HP Laserjet,Color Laserjet 3800 - Page 212

5. Press and until DELETE is highlighted on the product control panel, and then press .
6. Press
.
7. If a PIN number is assigned to the job, press
and to select the first digit of the PIN, and then
press
. The number in the product control-panel display changes to an asterisk. Repeat this
step for each of the remaining three digits of the PIN number.
If no PIN number is assigned to the job, continue with the next step.
8. Press
to delete the job.
Installable options
This section provides information to configure the printing options that you can install for the
HP Color LaserJet 3800 printer. The following controls are available:
●
Tray 3
●
Duplex Unit (for 2-sided Printing)
●
Mopier Mode
●
Printer Hard Disk
●
Job storage
●
VMOption. This option shows the amount of virtual memory (RAM) in the product.
Tray 3
This control specifies whether you have an additional 500-sheet feeder tray (Tray 3) installed on the
printer. The default setting is Uninstalled.
Duplex Unit (for 2-sided Printing)
The HP Color LaserJet 3800 printer is equipped with automatic 2-sided printing (duplexing), which
allows you to print on both sides of supported media. Automatic 2-sided printing is not supported for the
following media types:
●
Transparency
●
Labels
●
Extra Heavy
●
Cardstock
●
Tough Paper
●
Envelope
NOTE The HP Color LaserJet 3800 printer supports smart duplexing. The printer detects
information on both sides of the print job pages and runs the pages through the duplexing unit
only if printable information appears on the second side of the page.
188 Chapter 3 HP traditional print drivers for Windows ENWW