NOTE: For envelopes of other sizes, adjust the margin settings appropriately.
4. Click Print in the software program or printer driver.
Address type Left margin Top margin
Return 15 mm (0.6 in) 15 mm (0.6 in)
Destination 102 mm (4.0 in) 51 mm (2.0 in)
Configure tray 2 or tray 3 for custom paper
The printer automatically detects many sizes of paper, but you can also configure trays for custom paper
sizes. You must specify the following parameters:
●
Unit of measure (millimeters or inches)
●
X dimension (the width of the page as it feeds into the printer)
●
Y dimension (the length of the page as it feeds into the printer)
1
2
3
4
X
Y
1 Page length (Y dimension)
2 Page width (X dimension)
3 Media length guides
4 Media width guides
Use the following procedure to configure a tray for a custom size. Once a custom size is set for a tray,
it will be retained until the media length guides are reset.
Set a custom size in tray 2 or tray 3
1. Open the tray and place the media face-up in the tray.
2. Set the media length guides to the appropriate non-standard position and close the tray.
3. When the tray configuration message appears, press
.
4. Press
to change ANY CUSTOM to CUSTOM, and then press .
ENWW Configure trays 77
To Next Page
Loading...
