5. Press or to highlight the correct unit (either millimeters or inches), and then press .
After the unit of measure is set properly, set the X dimension as follows:
6. Press
or to highlight the correct value, and then press .
If the value entered is outside the valid range, Invalid value appears for two seconds. The control-
panel display prompts you to enter another value.
After the X dimension is set properly, set the Y dimension as follows:
7. Press
or to highlight the correct value, and then press .
If the value entered is outside the valid range, Invalid value appears for two seconds. The control-
panel display prompts you to enter another value. The printer shows a message indicating the
dimensions for the custom size.
Automatic media type sensing (auto sense mode)
The HP Color LaserJet CP3505 automatically classifies media into one of the following categories:
●
Plain
●
Transparency
●
Glossy
●
Extra-heavy glossy
●
Glossy film
●
Heavy
●
Light
The automatic media type sensor functions only when that tray is configured to Any Type Plain.
Configuring a tray to any other type, such as Bond or Glossy, deactivates the media sensor in that tray.
NOTE: Get optimal performance with the automatic media sensing feature when using original
HP media designed for use in HP color LaserJet printers.
NOTE: When printing on heavy media such as cardstock, glossy, or envelopes, achieve
optimum print quality by setting the media type through the control panel or software application
before printing the job.
Tray 1 sensing
Full sensing (default)
●
The printer stops at each page to sense media type.
●
This is the best mode for using mixed media in a single print job.
78 Chapter 6 Paper and print media ENWW
To Next Page
Loading...
