3. Place the paper face-up in the tray and make sure that it is flat at all four corners. Slide the paper length
and width guides so that they are against the stack of paper.
NOTE: The following sizes should not be rotated: letter, A4, Executive, and B5 (JIS). Load those media
types so that the long edge is against the right side of the tray.
4. Push down on the paper to make sure that the paper stack is below the paper limit tabs on the side of
the tray.
5. Slide the tray into the product.
48 Chapter 6 Paper and print media ENWW
To Next Page
Loading...