6. Holding the DIMM by the edges, align the notch on the DIMM with the bar in the DIMM slot at an angle.
7. Push down on the DIMM until both latches engage the DIMM. When the installation is correct, the metal
contacts are not visible.
NOTE: If you have difficulty inserting the DIMM, make sure that the notch on the bottom of the DIMM
is aligned with the bar in the slot. If the DIMM still does not go in, make sure that you are using the
correct DIMM type.
84 Chapter 9 Manage and maintain ENWW
To Next Page
Loading...