List of Messages
49
PAP BSY TOO LNG* Paper Busy Too Long. Firmware
error on the CMX controller
board.
1. Cycle power. Run the print job again.
If the message appears, download
the emulation software again (page
129).
2. Run the print job again. If the
message appears, power off the
printer. Remove the paper path or
pedestal top cover. Make sure
connectors P106 and P107 are fully
seated on the CMX controller board.
Make sure the MPU cable, the
hammer bank logic cable, and the
hammer bank power cable are
undamaged and have good
connections. Replace as necessary.
(Refer to Appendix A.)
3. Power on the printer. Run the print
job again. If the message appears,
replace the shuttle frame assembly.
4. Power on the printer. Run the print
job again. If the message appears,
replace the CMX controller board.
Record the message and return it
with defective CMX board.
PAP FIFO OVERFL* Paper First In First Out
Overflow. Firmware error on the
CMX controller board.
1. Cycle power. Run the print job again.
If the message appears, download
the emulation software again.
2. Power on the printer. Run the print
job again. If the message appears,
replace the CMX controller board.
Record the message and return it
with defective CMX board.
Table 2. Message List
Message Explanation Solution
To Next Page
Loading...
