Stapler/stacker door switch
Before proceeding, remove the following assemblies:
●
Stapler/stacker right door. See
Stapler/stacker right door on page 303.
Remove the stapler/stacker door switch
1. Move the stapler assembly to the back, remove four screws (callout 1), and then remove the right
rear inner cover (callout 2).
Figure 1-423 Remove the stapler/stacker door switch (1 of 3)
2
1
2. Disconnect two connectors (callout 1), and then release the wire harnesses from the retainers and
guide (callout 2).
Figure 1-424 Remove the stapler/stacker door switch (2 of 3)
2
1
ENWW
Output devices
315
To Next Page
Loading...