Stapler/stacker inlet solenoid assembly
Before proceeding, remove the following assemblies:
●
Stapler/stacker front right cover. See
Stapler/stacker front right cover on page 301.
●
Stapler/stacker front left cover. See
Stapler/stacker front left cover on page 302.
Remove the stapler/stacker inlet solenoid assembly
1. Disconnect one connector (callout 1), and then release the wire harness from the retainers (callout
2).
Figure 1-426 Remove the stapler/stacker inlet solenoid assembly (1 of 2)
1
2
ENWW
Output devices
317
To Next Page
Loading...