Stapler/stacker stapler assembly
Before proceeding, remove the following assemblies:
●
Stapler/stacker rear cover. See
Stapler/stacker rear cover on page 299.
Remove the stapler/stacker stapler assembly
1. Remove two screws (callout 1), and then remove the sheet-metal plate (callout 2).
Figure 1-428 Remove the stapler/stacker stapler assembly (1 of 3)
2
1
2. Release the wire harnesses from the retainer (callout 1), and then disconnect two connectors
(callout 2) .
Figure 1-429 Remove the stapler/stacker stapler assembly (2 of 3)
1
2
ENWW
Output devices
319
To Next Page
Loading...