Stapler/stacker controller PCA
Before proceeding, remove the following assemblies:
●
Stapler/stacker rear cover. See
Stapler/stacker rear cover on page 299.
Remove the stapler/stacker controller PCA
1. Disconnect all of the connectors on the stapler/stacker controller PCA.
Figure 1-432 Remove the stapler/stacker controller PCA (1 of 2)
2. Remove two screws (callout 1), release two tabs (callout 2) and then remove the PCA.
Figure 1-433 Remove the stapler/stacker controller PCA (2 of 2)
2
1
ENWW
Output devices
321
To Next Page
Loading...