Configure the product for Mailbox Mode or Stacker Mode
●
Step one: Access the HP Embedded Web Server (EWS)
●
Step two: Configure Mailbox Mode or Stacker Mode from the Embedded Web Server (EWS)
●
Step three: Configure the Stapler/Stacker settings
●
Step four: Configure the Staple/Collate settings
●
Step five: Configure the Hole Punch functionality
●
Step six: Configure the Output Bin
The mailbox mode allows each bin to be addressed individually. The stacker mode stacks the printed output
from the lowest bin to the top.
Use the Embedded Web Server (EWS) to configure the mode. Check the driver to make sure it is configured for
the new mode.
Step one: Access the HP Embedded Web Server (EWS)
1.
From the Home screen on the product control panel, touch the Network
button to display the IP
address or host name.
74 Chapter 2 Install and configure the finishing accessories ENWW
To Next Page
Loading...