Figure 1-97 Stack job offset example
Results Delivering 4 sets
Direction of delivery
1st set
2nd set
3rd set
4th set
Table 1-50 Motors for the stack job offset
Motor Function
Front-aligning-plate motor (M103) Aligns paper in the processing output bin to the front
Rear-aligning-plate motor (M104) Aligns paper in the processing output bin to the rear
Swing motor (M106) Moves the swing guide up/down
Stack trailing-edge assist motor (M109) Carry the stack end during stack ejection
Table 1-51 Sensors for the stack job offset
Sensor Function
Swing-guide home-position (HP) sensor (PI105) Detects the swing guide home position
Front-aligning-plate HP sensor (PI106) Detects the aligning plate front-home position
Rear-aligning-plate HP sensor (PI107) Detects the aligning plate rear-home position
Stack trailing-edge assist HP sensor (PI109) Detects the stack trailing-edge assist home-position
Stapler/stacker delivery modes
The stapler/stacker supports the following delivery modes.
Table 1-52 Stapler/stacker delivery modes
Feed Staple Punch Offset Supported feature
Face-down N N/A N Yes
Face-down N N/A Y Yes
Face-down Y N/A N Yes
Face-down Y N/A Y No
ENWW Stapler/stacker and stapler/stacker with hole punch 137
To Next Page
Loading...