Figure 1-100 Paper path for stapling
Stapler
Return roller
Stack ejection roller
Swing guide
1st delivery roller
Processing tray
Figure 1-101 Rollers and sensors for stapling
Swing guide
Swing motor
(M106)
Stack ejection motor (M102)
Swing guide home position sensor (P105)
Stack ejection lower roller cluch (CL102)
Stack ejection roller (lower)
Stack ejection roller (upper)
The stacker controller PCA starts the swing motor (M106) and lowers the swing guide when the rear
of the second paper passes the first delivery roller. The stack-delivery motor is reversed. The stack-
delivery motor rotates the stack-delivery roller (upper) and return roller and sends the paper to the
processing output bin. At this point, the stack-delivery roller (lower) does not rotate because the
stack-ejection lower roller clutch (CL102) is disengaged. The output-bin paper sensor (PI108) detects
the processing-output bin paper sensor (PI108). When the paper is delivered to the processing output
bin, the swing motor (M106) starts and raises the swing guide. When the swing-guide home-position
sensor (PI105) detects the rising of the swing guide, the swing-guide motor stops and holds the swing
guide at the raised position. After the processing-output-bin paper sensor detects the paper, the
aligning motor (M103/M104) starts and aligns the paper.
140 Chapter 1 Theory of operation ENWW
To Next Page
Loading...