Shift the staple unit
The stapler-shift motor (M105) shifts the stapler unit. The stapler-shift home-position sensor (PI110)
detects the home position. When there is a staple command from the product, the stapler shifts to the
staple ready position, which depends on the stapling position and paper size. The stapler unit waits at
the following points when staple mode is selected.
Figure 1-106 Front 1-point stapling
Front aligning plate
Stopper
Stapling position/
Wait position
Feeding direction
Rear aligning plate
Figure 1-107 Rear 1-point stapling
Front aligning plate
Stopper
Stapling position/
Wait position
Feeding direction
Rear aligning plate
ENWW Stapler/stacker and stapler/stacker with hole punch 143
To Next Page
Loading...