Hole puncher assembly jam detection
The hole puncher assembly uses the following sensors to detect the presence of the paper and to
check whether the paper is being fed correctly or has jammed:
●
Hole punch home position sensor (PI63)
●
Hole punch motor clock sensor (PI62)
●
Trailing edge detection sensor (LED5, PTR5)
Figure 1-112 Hole puncher assembly sensor location
PI62
PI63
Trailing edge detection sensor
(LED5, PTR5)
The stapler/stacker detects the following additional jams.
Table 1-57 Staple/stacker jam detection
Function Supported feature
Hole punch path delay jam Yes
Hole punch path stay jam Yes
Hole punching jam Yes
Residual paper jam (puncher assembly) Yes
ENWW Stapler/stacker and stapler/stacker with hole punch 153
To Next Page
Loading...