Figure 1-182 Output-bin components
Output bin 1
Paper surface sensor (PI41) (locate inside the accessory)
Edge
Output bin 2
Output bin 2 paper surface
sensor (PI48)
Edge
Paper surface sensor flag
Paper surface
sensor flag
When the output bin capacity is reached, the ON/OFF combinations of the area sensors (PS981,
PS982 and PS983) are used to determine an over-stacking condition. Area sensor conditions are as
follows:
Table 1-67 Stapler/stacker output bin 1shift area sensor PCA
Detection item Output bin 1shift area sensor PCA
Area sensor 1
(PS983)
Area sensor 2
(PS982)
Area sensor 3
(PS981)
Output bin 1 upper limit ON OFF OFF
Stack count 650 sheets exceeded ON ON ON
Stack count 1,300 sheets exceeded ON ON ON
Output bin 1 lower limit ON ON OFF
Table 1-68 Stapler/stacker output bin 2shift area sensor PCA
Detection item Output bin 2shift area sensor PCA
Area sensor 1
(PS983)
Area sensor 2
(PS982)
Area sensor 3
(PS981)
Output bin 2 upper limit ON OFF ON
Stack count 650 sheets exceeded ON ON ON
Stack count 1,300 sheets exceeded OFF ON ON
Stack count 1,700 sheets exceeded OFF OFF ON
Output bin 2 lower limit OFF ON OFF
ENWW Booklet maker and booklet maker with hole punch 203
To Next Page
Loading...