REPLACING THE HP P2035/2055 GEARLESS DRUM
By the Technical Staff at UniNet
HP P2035 • 2055 CARTRIDGE REMANUFACTURING INSTRUCTIONSHP P2035 • 2055 GEARLESS DRUM REPLACEMENT INSTRUCTIONS
© 2010 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact techsupport@uninetimaging.com
www.uninetimaging.com
Until replacement drums with gears become available, and while working on a HP P2055 cartridge requires replacement of the
drum, we have provided quick instructions on how to remove and install the gears/hub on the HP P2035/2055 cartridge:
SUPPLIES REQUIRED
New drum (optional) UniNet #13372 - HP P2035/2055 gearless recommended.
TOOLS REQUIRED
1. Metal 3/16” rod or long flat head screw driver type, about 12” to 18” long
2. Pliers
3. Super glue or equivaliant
4. Rubber mallet
5. Volt meter
CAUTION: Please make sure you are wearing proper protective gear while performing the procedures from this article.
1. Swivel hub on the OPC drive gear shown. 2. Remove the swivel hub on the drive gear by pulling it out
using pliers.
To Next Page
Loading...