HP P2035 • 2055 GEARLESS DRUM REPLACEMENT INSTRUCTIONS
© 2010 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact techsupport@uninetimaging.com
www.uninetimaging.com
4. Straighten out the contacts on the contact hub and do the
same for the contact gear.
Make sure you do not place the contacts that bite into the
drum in the glue or there will be drum ground issues (blank
pages).
REMOVING THE DRUM GEAR
3. Slide a 3/16" metal rod or long flat head screw driver, about
12-18" long, long the drum wall until it meets the side wall of
the gear. Lightly tap the rod a few times with a hammer, rotate
the drum, do the same until it comes loose. Normally three to
four times you have to tap it.
Do the same for the contact side taking care not to place the
rod anywhere near the copper contacts that bite into the drum.
5. Clean the contacts with a cotton swab and alcohol.
6. Apply a thin layer of super glue around the contact hub and
install into the new drum (avoid getting glue into the contacts
and drum coating).
To Next Page
Loading...