HP P2035 • 2055 GEARLESS DRUM REPLACEMENT INSTRUCTIONS
© 2010 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact techsupport@uninetimaging.com
www.uninetimaging.com
8. Install the drive gear. Place the drum onto a flat surface and
gently tap the gear with a rubber mallet until the gears sits
flush.
9. Install the swivel hub into the drive gear.
7. Place a few drops of medium or thick super glue on the
inside wall of the gear (not on the edge) about 1/8' to 1/4"
from the edge, depending on the gear size (this will prevent the
glue from overflowing into the drum coating when the drive
gear is installed).
10. Check the drum ground with an ohm meter. Place the
probes into the drum contact and drum (very edge on the
drum where there is no coating), and check for continuity.
Be very careful to keep the one lead on the edge of the drum.
The top metal part has a clear protective coating on it and is
easily scratched. Do not press in hard or the lead will slide
across the drum ruining it.
Allow the glue to dry for about a couple of minutes and the
drum should be ready to use.
To Previous Page
Loading...