2. Disconnect two FFCs (callout 1), and then release them from the guides (callout 2).
CAUTION: Do not bend or fold the flat flexible cables (FFCs) during removal or installation.
Also, do not straighten pre-folds in the FFCs.
Figure 1-14 Remove the document feeder (2 of 4)
1
2
3. Release the tabs inside the hinges (callout 1) to allow the scanner assembly to slide down on the
hinges.
Figure 1-15 Remove the document feeder (3 of 4)
1
ENWW
Removal and replacement procedures
19
To Next Page
Loading...
