HP LaserJet Pro 100 - Page 45

Rear door assembly
Before proceeding, remove the following components:
●
Right cover. See
Right cover on page 16.
Remove the rear door assembly
1. Remove one screw (callout 1) and the bushing (callout 2).
Figure 1-27 Remove the rear door assembly (1 of 2)
2
1
2. Pull out the shaft (callout 1) and remove the rear door assembly (callout 2).
Figure 1-28 Remove the rear door assembly (2 of 2)
2
1
ENWW
Removal and replacement procedures
27