Control panel
CAUTION: ESD sensitive.
Before proceeding, remove the following components:
●
Right cover. See
Right cover on page 16.
●
Left cover. See
Left cover on page 17.
●
Document feeder. See
Document feeder on page 18.
●
Document feeder hinges. See
Document feeder hinges on page 21.
●
Top door, rear-top cover, and delivery cover. See
Top door, rear-top cover, and delivery cover
on page 22.
Remove the control panel
1. Disconnect one FFC (callout 1), and then release the FFC from the guide (callout 2).
CAUTION: Do not bend or fold the flat flexible cables (FFCs) during removal or installation.
Also, do not straighten pre-folds in the FFCs.
Figure 1-30 Remove the control panel (1 of 3)
1
2
ENWW
Removal and replacement procedures
29
To Next Page
Loading...
