Tools for troubleshooting
Component diagnostics
LED diagnostics
Network LEDs
The onboard network solution has two network port LEDs. When the product is connected to a properly
working network through a network cable, the yellow LED indicates network activity, and the green LED
indicates the link status. A blinking yellow LED indicates network traffic. If the green LED is off, a link
has failed.
For link failures, check all of the network cable connections. In addition, you can try to manually
configure the link settings on the onboard network solution by using the product control-panel menus.
1. Touchscreen control panel:
a. Touch the Setup
button.
b. Scroll to and touch the Network Setup menu.
c. Touch the Link Speed menu.
2. LCD control panel:
a. On the control panel, press the OK button to open the menus.
b. Open the following menus:
◦
Setup Menu
◦
Network Setup
◦
Link Speed
3. Select one of the following options.
Setting Description
Automatic The print server automatically configures itself for the highest link speed and
communication mode allowed on the network.
10T Half 10 megabytes per second (Mbps), half-duplex operation
10T Full 10 Mbps, full-duplex operation
100TX Half 100 Mbps, half-duplex operation
100TX Full 100 Mbps, full-duplex operation
28 Chapter 2 Solve problems ENWW
To Next Page
Loading...