Clean the product
During the printing process, paper, toner, and dust particles can accumulate inside the product. Over
time, this buildup can cause print-quality problems such as toner specks or smearing. This product
has a cleaning mode that can correct and prevent these problems.
1. At the control panel, press the OK button to open the menus.
2. Open the following menus:
●
Service
●
Cleaning Page
3. Load plain paper in Tray 1, and then press the OK button to start the cleaning process. Wait until
the process is complete. Discard the page that prints.
NOTE: For models that do not have an automatic duplexer, the product prints the first side and
then prompts you to remove the page from the output bin and reload it in Tray 1, keeping the
same orientation.
Product updates
Software and firmware updates and installation instructions for this product are available at
www.hp.com/support/LJColorM351 or www.hp.com/support/LJColorM451. Click Support & Drivers,
click the operating system, and then select the download for the product.
ENWW
Clean the product
133
To Next Page
Loading...
