HP LaserJet Pro CP1525 - Color Printer - Page 132

Secondary service menu structure
Table 2-3 Secondary Service menu
Menu item Sub-menu item Description
Service Reports Cont. Self-Test Print a continuous configuration page.
Error Report Print an error report.
Location A list of available locations
appears
This item sets certain product parameters that are dependent on the
location, such as the default paper size and the symbol set.
Scroll to the appropriate location and select Yes to set the location. The
product automatically restarts after you change the location.
Display test Use this test to verify that the LEDs and characters on the control-panel
display function correctly.
At the beginning of the test, each of the LEDs is turned on one-at-time.
Press the OK button to continue to the next LED.
After the LED test is complete, the character test begins by testing the
pixels on each line. Then, each of the 255 characters is displayed in
groups of 16. Press the OK button to continue to the next group of 16
characters. You can cancel the test at any time by pressing the
Cancel
.
Button test Use this test to verify that the control-panel buttons function correctly.
The display prompts you to press each button.
Firmware date This item shows the current date code of the firmware.
Color Cal. Adjust color Use this item to adjust density settings for contrast, highlights, midtones,
and shadows. Adjust each color individually.
Timing Use this item to specify how frequently the product should automatically
perform a color calibration. The default setting is 48 hours. You can turn
automatic calibration off.
Enter MAC Addr. Use this item to specify the MAC address for the product. The MAC
address is in hexadecimal code. Use the right arrow
button to scroll
through the possible values for each character. When a digit is correct,
press the OK button to move to the next digit.
LED Test The LED’s turn on one at a time during the test. Press OK to continue to
the next LED.
Clean Belt This item runs additional belt-cleaning cycles.
Pick roller This item puts the pickup roller in position for replacement.
Engine resets
Engine test page
1. With the product power off, open the front and rear doors.
2. Turn the power on, and close both doors within ten seconds.
3. An engine test page (a page containing multiple horizontal colored lines) will print.
114 Chapter 2 Solve problems ENWW