HP LaserJet Pro CP1525 - Color Printer - Page 22

After performing service
● Plug in the power cable.
● Reinstall the print cartridge.
●
Load paper in the product.
Post-service test
Perform the following test to verify that the repair or replacement was successful.
Print-quality test
1. Verify that you have completed the necessary reassembly steps.
2. Make sure that the tray contains clean, unmarked paper.
3. Attach the power cord and interface cable or interface cables, and then turn on the product.
4. Verify that the expected startup sounds occur.
5. Print a configuration page, and then verify that the expected printing sounds occur.
6. Print a demo page, and then verify that the print quality is as expected.
7. Send a print job from the host computer, and then verify that the output meets expectations.
8. Clean the outside of the product with a damp cloth.
Parts removal order
Use the following diagram to determine which parts must be removed before removing other parts.
Figure 1-2 Parts-removal order
Print cartridges
Pickup roller
Separation roller
Cartridge drawer
Tray 2
Tray 2
Transfer roller
Feed assembly
Right cover
Tray 2
Right cover
Right cover
Right cover
Right cover
Tray 2
Left cover
Left cover
Right cover
Right cover
Right cover
Right cover
Right cover
Right cover
Right cover
Right cover
Right cover
Right cover
Control-panel module
Control-panel module
Front door and Tray 1 door
Rear-upper cover
Rear-side cover
Rear door and rear-lower cover
Left cover
Rear-side cover
Rear-side cover
Rear-side cover
Rear-side cover
Right cover
Left cover
Rear-side cover
Control panel module
Rear-side cover
Control panel module
Control panel module
Top cover
Left cover
Left cover
Left cover
Left cover
Left cover
Left cover
Main motor
Control panel module Rear-side cover
Rear-side cover
Rear-upper cover
Rear-side cover
Rear door and
rear-door lower cover
Rear door and
rear-door lower cover
Rear-side cover
Rear-upper cover
Rear-upper cover
Top cover
Rear-upper cover
Rear-upper cover Rear door and
rear-door lower cover
Top cover
Component Remove
Remove
Remove Remove
Remove
Remove Remove
Fuser motor
Intermediate transfer belt
DC controller PCA
Formatter PCA
Wireless PCA
Power supply (high-voltage)
Power supply (low-voltage)
Power supply (fuser)
Fuser
4 Chapter 1 Removal and replacement ENWW