9. Carefully lift up on the black plastic portion of the ITB, and then pull it partially out of the product
(the ITB wire harness will prevent the ITB from being fully removed).
WARNING! Only partially pull the ITB out of the product to avoid damage to the secondary-
transfer (T2) roller.
CAUTION: Avoid touching the black plastic transfer belt. Skin oils on the belt might cause
print-quality problems.
Figure 1-52 Remove the ITB (7 of 9)
10. Feed the ITB wire harness (callout 7) through an opening in the chassis (callout 8).
Figure 1-53 Remove the ITB (8 of 9)
7
8
ENWW Removal and replacement procedures 33
To Next Page
Loading...