11. Carefully pull the ITB straight out of the product.
WARNING! Handle the ITB by its hard plastic sides to avoid damage to the sheet-metal frame.
The lower sheet-metal portion of the ITB frame can be easily bent. See
Figure 1-55 Reinstall the
ITB (1 of 2) on page 35.
CAUTION: Make sure that the ITB wire harness does not get damaged as the ITB is removed
from the chassis.
Figure 1-54 Remove the ITB (9 of 9)
34 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...