2. Remove one FFC using the blue tab (callout 1).
Figure 1-129 Remove the document feeder core assembly (2 of 3)
1
TIP: The orientation of the FFC is important. When reinstalling it, make sure the blue tab is
toward the product right side. If the FFC is installed upside-down, the document feeder does not
work.
3. Release one hinge (callout 1), and then remove the document feeder core assembly.
Figure 1-130 Remove the document feeder core assembly (3 of 3)
1
ENWW Removal and replacement procedures 83
To Next Page
Loading...
