Customer self repair parts
Table 3-5 Customer replaceable units (CRU) kit part numbers
Item Description Part number
Output bin Output bin
Installation instructions
RM1-7498-000CN
Dust cover Dust cover for the input tray
Installation instructions
RC2-9578-000CN
Paper pickup tray assembly Input tray
Installation instructions
RM1-7534-000CN
Pickup roller Pickup roller
Installation instructions
RL1-1497-000CN
Separation pad assembly Separation pad
Installation instructions
RM1-4227-000CN
Document feeder input tray Document feeder input tray
Installation instructions
CE538-60127
Service parts
NOTE: The parts in the following table are not shown in the assembly illustrations in this chapter.
Table 3-6 Service parts
Item Description Part number
HP jewel HP logo 7121-8266
Regulatory label Blank label 5969-9497
How to use the parts lists and diagrams
CAUTION: Be sure to order the correct part. When looking for part numbers for electrical
components, pay careful attention to the voltage that is listed. Doing so will make sure that the part
number selected is for the correct model.
NOTE: In this manual, the abbreviation “PCA” stands for “printed circuit-board assembly.”
Components described as a PCA might consist of a single circuit board or a circuit board plus other
parts, such as cables and sensors.
The figures in this chapter show the major subassemblies in the product and their component parts. A
parts list table follows each exploded view assembly diagram. Each table lists the item number, the
associated part number, and the description of each part. If a part is not listed in the table, then it is
not a service part.
ENWW How to use the parts lists and diagrams 195
To Next Page
Loading...
