4. Disconnect one connector (callout 1), and then remove the wire harness (callout 2) from the
guide (callout 3).
NOTE: Callout 1 indicates three connectors. Disconnect the one that is furthest to the left
(J562).
Figure 1-86 Remove the pickup solenoid (4 of 6)
1
2
3
5. Release the wire harness (callout 1) from the guide (callout 2).
Figure 1-87 Remove the pickup solenoid (5 of 6)
1
2
ENWW Removal and replacement procedures 57
To Next Page
Loading...
