2. Remove two screws (callout 1), and then remove the sheet-metal corner brace (callout 2).
Figure 1-90 Remove the engine controller PCA (2 of 9)
1
2
3. Disconnect one connector (callout 1), remove one wire harness from the guide, (callout 2), and
then remove five screws (callout 3) to remove the sheet metal plate.
Figure 1-91 Remove the engine controller PCA (3 of 9)
2
3
1
60 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...
