Reinstall the engine controller PCA
NOTE: To install the transfer wire harness correctly, follow these steps in addition to the steps in
reverse order of removal.
1. Place the engine controller PCA into the product so that the cartridge door switch lever (callout
1) engages correctly with the switch on the PCA (callout 2).
Figure 1-98 Reinstall the engine controller PCA (1 of 5)
1
2
2. Set the ground spring (callout 1) on the transfer wire harness (callout 2).
Figure 1-99 Reinstall the engine controller PCA (2 of 5)
1
2
64 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...
