4. On the Device Information page, the default product name is in the Device Status field. You can change
this name to uniquely identify this product.
NOTE: Completing the other fields on this page is optional.
5. Click the Apply button to save the changes.
Manually configure IPv4 TCP/IP parameters from the control panel
Use the control-panel menus to manually set an IPv4 address, subnet mask, and default gateway.
1. On the product control panel, press the OK button.
2. Open the following menus:
●
Network Setup
●
IPV4 Config Method
●
Manual
3. Use the arrow keys to enter the IP address, and press the OK button. Press the OK button again to
confirm.
4. Use the arrow keys to enter the subnet mask, and press the OK button. Press the OK button again to
confirm.
5. Use the arrow keys to enter the default gateway, and press the OK button. Press the OK button again to
confirm.
44 Chapter 5 Manage the product ENWW
To Next Page
Loading...