Tray adjustment for short media (base models only)
To print on media shorter than 185 mm (7.28 in), use the short media extender to adjust your input
tray.
1. Remove the short media extender tool from the storage slot on the left side of the media input
area.
2. Attach the tool to the adjustable media guide.
3. Insert the media into the product until it stops, and then slide the adjustable media guide, with the
tool attached to support the media.
4. When finished printing with short media, remove the short media extender tool, and then place it
back in the storage slot.
ENWW
Load paper trays
41
To Next Page
Loading...