Face-down cover
Before proceeding, remove the following components:
●
Input tray or main-input tray. See
Input tray or main-input tray on page 40.
●
Output bin tray extension. See
Output bin tray extension on page 41.
●
Front cover. See
Front cover on page 42.
●
Left cover. See
Left cover on page 43.
●
Right cover. See
Right cover on page 46.
●
Cartridge door assembly. See
Cartridge door on page 48
Remove the face-down cover
1. Release two tabs (callout 1), and slightly separate the face-down cover from the rear cover.
Figure 2-20 Remove the face-down cover (1 of 2)
1
50 Chapter 2 Removal and replacement ENWW
To Next Page
Loading...