2. Remove four screws (callout 1), the scanner cover (callout 2) and the sheet-metal plate (callout 3).
NOTE: The scanner cover and plate are removed as one assembly.
TIP: When the cover is reinstalled, make sure that the black screws (callout 4) are installed in
the correct screw holes.
Figure 2-30 Remove the laser/scanner assembly (2 of 4)
1
2
3
4
3. Disconnect one FFC (callout 1), and then remove four screws (callout 2).
Figure 2-31 Remove the laser/scanner assembly (3 of 4)
1
2
ENWW Main assemblies 59
To Next Page
Loading...