Pickup solenoid
Before proceeding, remove the following components:
●
Input tray or main-input tray. See
Input tray or main-input tray on page 40.
●
Output bin tray extension. See
Output bin tray extension on page 41.
●
Front cover. See
Front cover on page 42.
●
Left cover. See
Left cover on page 43.
●
Right cover. See
Right cover on page 46.
●
Cartridge door assembly. See
Cartridge door on page 48
●
Face-down cover. See
Face-down cover on page 50.
●
Rear cover. See
Rear cover on page 52.
●
Formatter PCA. See
Formatter PCA on page 54.
●
Wireless PCA. See
Wireless PCA on page 57.
Remove the pickup solenoid
1. Remove three screws (callout 1), and then remove the plastic plate (callout 2).
Figure 2-63 Remove the pickup solenoid (1 of 5)
2
1
ENWW Main assemblies 77
To Next Page
Loading...