HP LaserJet Pro P1100 - Page 98

Engine controller PCA
NOTE: Some photos in this section show a product similar to the HP LaserJet Professional P1100
Printer series or the HP LaserJet Professional P1100w Printer series, however the procedures for
replacement and repair in this section are correct for your product.
Before proceeding, remove the following components:
●
Input tray or main-input tray. See
Input tray or main-input tray on page 40.
●
Output bin tray extension. See
Output bin tray extension on page 41.
●
Front cover. See
Front cover on page 42.
●
Left cover. See
Left cover on page 43.
●
Right cover. See
Right cover on page 46.
●
Cartridge door assembly. See
Cartridge door on page 48
●
Face-down cover. See
Face-down cover on page 50.
●
Rear cover. See
Rear cover on page 52.
●
Formatter PCA. See
Formatter PCA on page 54.
●
Wireless PCA. See
Wireless PCA on page 57.
Remove the engine controller PCA
1. Remove three screws (callout 1), and then remove the plastic plate (callout 2).
Figure 2-68 Remove the engine controller PCA (1 of 8)
2
1
80 Chapter 2 Removal and replacement ENWW