Engine controller PCA
Before proceeding, remove the following components:
●
Main-input tray. See
Main-input tray on page 43.
●
Output bin tray extension. See
Output bin tray extension on page 44.
●
Left cover. See
Left cover, simplex product on page 45 or Left cover, duplex product on page 47.
●
Right cover. See
Right cover, simplex product on page 50 or Right cover, duplex product
on page 52.
●
Duplex frame. See
Duplex frame, duplex product on page 56.
NOTE: Duplex models only.
●
Cartridge door. See
Cartridge door on page 57
●
Rear cover or duplex door. See
Rear cover, simplex product on page 63 or Duplex door, duplex
product on page 55.
●
Control panel. See
Control panel on page 59.
●
Face-down cover. See
Face-down cover on page 65.
Remove the engine controller PCA
1. Duplex models only: Release two tabs (callout 1), and then remove the duplex reverse guide
(callout 2).
Figure 2-95 Remove the engine controller PCA (1 of 9)
1
2
ENWW Main assemblies 97
To Next Page
Loading...