12 – Control panel messages
EN
SIMM Errors
Remove all SIMMs and power cycle the printer. Retry the operation.
Replace the SIMMs one at a time to locate the defective module. Refer
to the Service Manual for details.
Fatal Errors
When the DATA, TRAY 2, TRAY 1, and ERROR LEDs are on, press [Go]
and [Reset] simultaneously and follow the instructions for the secondary
light patterns shown.
Item Description Recommended Action
6 Error 53-0 ROM error See note below
7 Error 53-1 RAM error See note below
Item Description Recommended Action
8 Primary light pattern See note on primary and
secondary lights, page 13
8-1 Error 50 fuser See page 44
8-2 Error 57/58 (main motor) See page 54
8-3 Error 61.x (x=1, 2, 3 SIMM) See page 58
8-4 Error 62.x (x=1, 2, 3 SIMM) See page 59
8-5 Error 62.0 See page 58
8-6 Error 63, 64, 64, 65 See pages 59–60
8-7 All other errors See pages 61–72
To Next Page
Loading...
Need help?
General
