48 – Control panel messages
EN
4 Plus, 4
• The laser scanner cable is faulty.
• The laser scanner assembly is defective.
IIIP, IIP Plus, IIP
• The scanner motor is bad.
• The DC controller is bad.
IIID, III, IID, II
• The laser scanner cable to the DC controller is defective.
– Replace the cable assembly (part number RG1-0908-000CN).
• The laser scanner assembly is defective.
2868A/D
• The scanner assembly is defective.
5Si
• Scanner subsystem problem.
If x=1: Scanner startup failure.
If x=2: Scanner rotation failure
– Switch the printer off and then back on.
If the error continues:
Check the cable from the DC controller to the laser scanner
assembly.
Replace the laser scanner assembly.
Replace the DC controller PCA.
52.x Error