EN
Error Codes –
61
1
5Si
If the control panel displays a 66.x.yy device error message, the printer
will list additional error codes in the error log. These can be printed or
viewed. A device error message indicates a paper-handling error. The
printer is unable to communicate with the external paper handling PCA.
Verify that the C-link cables are installed correctly. Print the PCL
configuration page and note which installed devices are not present on
the configuration page.
x=paper-handling device
0=external paper handling (EPH) PCA
1=first device attached to EPH
2=second device attached to EPH
3=third device attached to EPH
4=fourth device attached to EPH
5=fifth device attached to EPH
– Switch the printer and paper-handling devices off and then on. If
the message persists:
yy=paper-handling device error code
If yy=1-22, 24:
– Check the cabling between the printer and the device.
Check the mechanical interface between the printer and the
device.
Replace the external paper-handling PCA.
If yy=23:
– Check the cabling and mechanical interface between the printer
and the device.
Replace the external paper-handling PCA.
Repeat steps 1 and 2 to isolate the defective device.
Repair or replace the defective device.
66.x.yy Device Error
To Next Page
Loading...
Need help?
General
