HP LaserJet - Page 62

TRANSPARENT PRINT DATA
The following escape sequence allows you to send data to the
printer without the printer performing any escape sequences or
control codes (even CR and EeZ):
EC&p#X[transparent print data]
#
= Number of bytes of print data
The value field (#) specifies the number of bytes of print data
that will follow. The print data should follow immediately after
the X.
PERFORATION SKIP MODE
The perforation skip mode controls the bottom margin. If
perforation skip mode is OFF, the bottom margin is disabled; if
the perforation skip mode is ON, the cursor position skips to the
next top margin when the bottom margin is entered. The
following escape sequences control the automatic perforation skip
mode:
Perforation skip mode ON Ee&I1L
Perforation skip mode OFF Ec&10L
The perforation region is defined as the area outside the text area
but within the page. If the perforation skip mode is on (default)
and a Line Feed or Half Line Feed causes the current active
position
to enter the perforation region, the current page will be
ejected from the printer. NOTE: If you print in the perforation
skip region,
the unprintable region may be entered. Attempting to
print in the unprintable region results in data loss.
2-43