When a reset
is
sent
to
the
printer
or
the printer
is
powered-on,
the
starting cursor position
is
determined using the
current
top
margin
and
left margin settings (those settings in
effect
when the
first print data
is
received
or
when a command
affecting
the
current
active printing position
is
received). Following reset, there
are
60
printable lines (10 inches
at
6 lines/inch).
After
receiving
an
EcE,
if
a page length, orientation,
top
margin,
left
margin, VMI
or
line spacing command
is
received before any
printable
data
or
commands affecting
the
current
active position
is
received, the starting cursor position
is
fixed
and
the current
active position
is
not
affected
by successive changes
to
the
top
margin, left margin, VMI
or
line spacing. Once the starting cursor
position
is
fixed, changes
to
page length
or
orientation cause a
Form
Feed and a Carriage Return
to
be executed. Space
characters, Carriage Return,
and
Horizontal Moves
do
not
cause
the
starting cursor position
to
be fixed (that
is,
if
only these
commands are received
at
the beginning
of
a page,
an
EcE will not
ca use
the
page
to
be ejected).
NOTE
If
the printer
is
in manual feed mode and an EcE
is
sent
to
the
printer, the reset will
not
cause
the
MANUAL
FEED
light
to
turn
off
until
the
printer
is
ready
to
feed paper
from
the
paper
cassette.
The
following table lists
the
default
values
of
the
printer features.
2-49
To Next Page
Loading...
