HP LaserJet - Page 70

• Vertical Line Spacing
Vertical line spacing-6 lines per inch
• Raster Graphics
Raster graphics resolution-75 dots/inch
• Horizontal Cursor Spacing (HMI)
Horizontal Motion Index (HMI)--12/ 120
• Display Functions
Display functions mode--OFF
• Perforation Skip Mode
Perforation skip mode--Enabled
• Miscellaneous Features
Line termination--CR=>CR; LF=>LF; FF=>FF
End-of -line wrap--Disabled
Portrait
or landscape orientation--Portrait
Select number
of copies--One
Paper input control--Feed
from paper input cassette (or upper
cassette
for LaserJet 500+)
SELF-TEST
Sending the ECZ escape sequence causes an interface self-test to be
performed (the printer has a built-in interface). When the
command is received by the printer, the printer stops processing
data and prints the current page (a Carriage Return and Form
Feed are executed). Immediately following this, the self-test is
performed without data loss. If no error is detected in the
self-test, the printer will remain on-line, ready to print a new page.
If an error is detected, the printer is automatically set off-line.
For information on self-test errors, see the "Correcting Self-Test
Errors" discussion in
Chapter V of the LaserJet Printer Operator's
Manual.
2-51