Paper-pickup assembly
1. Remove the following assemblies:
●
Product base separation pad. See
Separation pad (product base) on page 96.
●
Scanner assembly. See
Scanner assembly on page 90.
●
Transfer roller. See
Transfer roller on page 103.
●
Right and left cover. See
Side covers on page 104.
●
Print-cartridge door. See
Print-cartridge door on page 106.
●
Rear cover and fuser cover. See
Rear cover and fuser cover on page 107.
●
Front cover. See
Front cover on page 109.
●
Formatter and fax card. See
Formatter and fax card on page 113.
●
Fuser. See
Fuser on page 128.
2. Release one tab (callout 1). Rotate the paper-pickup drive-shaft locking clip until the clip retainers
align with the holes in the chassis, and then remove the clip.
Figure 5-98 Remove the paper-pickup assembly (1 of 4)
1
132 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...