Calibrate the scanner from HP ToolboxFX
1. Open HP ToolboxFX.
2. Click the product, and then click the Device Settings folder.
3. Click the Print Quality page, and then select Calibrate now.
4. Click Apply to start the calibration process.
Calibrate the scanner from the product control panel
1.
At the control panel, press Setup
.
2. Open the Secondary Service menu by pressing and holding both the down arrow button and the
Cancel button.
3.
Press Setup
again.
4. Use the arrow buttons to select Calibrate, and then press OK.
5. Use the arrow buttons to select the calibration mode, and then press OK.
The product scanner calibrates slowly. When the calibration process completes, the product prints
a calibration report.
ENWW Clean the product 35
To Next Page
Loading...