Flatbed lid
1. Open the ADF cover. Carefully pry the ADF motor cover off (from right to left) and away from the
scanner assembly.
Figure 5-5 Remove the flatbed lid (1 of 5)
1
3
2
Reinstallation tip When you reinstall the ADF motor cover, make sure that it is positioned
correctly. If the motor cover is not installed correctly, the ADF lid will not close correctly, resulting
in intermittent ADF errors. Verify that the motor cover snaps over the corner of the sheet metal
chassis.
Figure 5-6 ADF cover correctly installed
76 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...