Manually configure IPv4 TCP/IP parameters from the control panel
Use the control-panel menus to manually set an IPv4 address, subnet mask, and default gateway.
1. On the product control panel, press or touch the Setup
button.
2. Scroll to and open the Network Setup menu.
3. Open the IPv4 Config menu, and then select Manual.
4. Use the keypad to enter the IP address, and press or touch the OK button.
5. Use the keypad to enter the subnet mask, and press or touch the OK button.
6. Use the keypad to enter the default gateway, and press or touch the OK button.
82 Chapter 8 Manage the product ENWW
To Next Page
Loading...